8
Instructions:
Before the unit is used you must make sure that the battery is charged. Take the unit out of the case and hit the power button. The
battery icon on the screen should be partially or fully shaded dark to indicate battery life. If the battery icon is empty of ashing then
recharge the unit (see: charging instructions)
Make sure all knobs are in the off position and that the recharger is unplugged from the back of the machine. Take the gray lead wires
out and plug the plastic end into the channel A output jack. Take the black lead wires out and plug the plastic end into the channel B
output jack.
Take out a package of electrodes, and remove from Ziploc bag. Next connect the 4 pins on the end of the lead wires to each of the four
electrodes. Place the electrodes on the skin according to the diagrams on the following pages. Note: Skin should be clean and dry.
Get into a relaxed and still position (laying down, sitting in a chair or on a couch). You should be comfortable and the muscles being
worked should be free to contract without resistance.
(If you are tense and resist the contractions or if you’re in a position that causes signicant resistance you will not benet from the Marc Pro Plus)
Once the pads are in place, hit the power button at the top of the interface. Next select the frequency for each channel according to
the instructions on the following pages.
Next click on the Channel A and B Intensity knobs and slowly turn up each knob according to your tolerance. The session protocols
on the following pages will give you an ideal setting range for each channel.
-For Low Frequencies:
You will start to feel a gentle rhythmic pulsating sensation that will get stronger and stronger as you turn the dial up. A strong visible
contraction is possible and desirable in most areas of the body. An intensity level between 6-9 is commonly reached, but it is OK to
turn the intensity up slowly. In general the higher the intensity the better the results will be; however, it is very important that the signal
level stay within your tolerance.
(Remember: As long as the intensity is not raised above your tolerance and you don’t resist the contractions, even extremely strong and
visible contractions will not fatigue your muscles. This is ideal for conditioning and is what makes the Marc Pro Plus technology so unique)
-For High Frequencies
You will start to feel a gentle buzzing/vibration that will get stronger as you turn up the dial. An intensity level between 4-9 is commonly
reached, but it is OK to turn the intensity up slowly. In general the buzzing sensation should be felt over your pain level and typically
the higher the intensity the better the results will be. However, it is very important that the signal level stay within your tolerance.
Step 1
Step 2
Step 3
Step 4
Step 5
To Next Page
Loading...
