7
Care of your Marc Pro Plus
Physical Characteristics:
Length 7 inches
Width 4 inches
Height 2 inches
Weight 1 lb 6 oz
Recharging the Battery:
• Before use, be sure that the battery is
charged. After powering on the device
a battery indicator on the LCD screen
will give the current level. If the battery
icon is fully or partially shaded then the
device can be used.
• If the battery icon is empty or ashing,
the device should be charged.
• To charge, plug the recharger into the
back of the unit and into the wall outlet.
Charge for 8-12 hours, or overnight.
• When done recharging always
remember to unplug the recharger
from the back of the machine, if it is left
in, the unit will not work.
• A fully charged battery should last for
10 or more hours of use.
Electrode Use and Care:
• When electrodes (pads) are not in use always place on
plastic sheet and seal in Ziploc bag.
• We recommend that you change pads after 20 uses because
conductivity will decrease due to body oils accumulated on electrodes.
• Old or worn electrodes can also reduce the comfort of stimulation.
• Only use the electrodes supplied by Marc Pro. Other electrodes may
present a risk of unsuitable electrical characteristics with your stimulator.
• Do not use the same electrodes on several different people.
• Do not plunge the electrodes into water.
• Do no apply a solvent of any kind onto the electrodes
• Always stop the stimulator before removing or moving the electrodes.
• Always place electrodes on dry, clean, oil and lotion free skin.
• If you’re using an optional aloe based skin gel: use a small amount (about the
size of a pea) under each electrode. Rub completely into the skin before placing
electrode. This can help ensure the most comfortable and strongest signal.
NOTE: Electrode is 2 inch round with conductive hydrogel w/.08” round female
connector; not to exceed 0.1 Watt/cm2.
To Next Page
Loading...
