automatic management to manual management, open all permissions (allow Auto-launch,
Secondary launch, Run in background). This is only for the application to maintain the Bluetooth
connection with the watch while the phone is in standby mode (the phone does not have a bright
screen). This permission will not use network traffic, nor does it affect the power consumption of
the phone.
3. Link APP and Watch
3.1 Open the app and set your personal information, such as “Height”, “Weight”, “Birth Year”, etc.
3.2 Switch to the home page, click “Add a Device” and click on the icon with the model number of
your smart watch.
3.3 It will automatically switch to the home page after a successful connection between app and
watch. Click the device icon to switch to the device page to check connection status. This page
will also show the device model and picture, battery, device address and other information.
3.4 For iPhone users: when pairing fails, check that the phone is not connected to other devices.
If so, in phone settings, enter to Bluetooth settings and ignore the other device on the phone
before a new pairing.
4. APP functions (available after connected successfully)
4.1 Watch faces: Select a dial and click on the top left corner to return and save it.
4.2 Notifications: You can select the notifications you want to receive on your smart watch.
4.3 Alarms: There are 3 different alarms available. Click on them to set the alarm time.
4.4 Shutter:
Android phone users: Click the shutter function on the APP and the watch will show a
camera icon. Click it to take a photo on your phone. Photos will be automatically saved
on the album in your phone.
iPhone users: it is necessary to open the camera on the phone manually (due to the iOS
system) and then click to take pictures from the watch.
4.5 Others:
4.5.1 Find Device: The smart watch will vibrate so you can find it.
4.5.2 “Do not disturb”: Default mode is OFF. You can set the “do not disturb” mode
according to your personal needs. The smart watch will not receive notifications while it is
ON.
4.5.3 Sedentary reminder: Default mode is OFF. You can set the reminder according to your
personal needs.
4.5.4 Turn on screen by turning wrist: Default mode is ON. When it is ON, the smart watch
screen will automatically turn on when the wrist is turned.
4.6 Upgrade: When a new version of the software is detected, it can be upgraded.
4.7 Remove: To unlink the phone and smart watch.
Note: For iPhone users, go to “Settings” - “Bluetooth”, to ignore current Bluetooth pairing in
To Next Page
Loading...
