order to unlink completely.
5. Smart watch functions
5.1 Basics
5.1.1 Turn ON: When the watch is turned off, long press the side button for 5 seconds to turn on.
In the standby state, short press the side button to wake it up.
5.1.2 Turn OFF: When the watch is turned on, long press the side button for 5 seconds to turn it
off directly.
5.1.3 Messages: Slide down the main dial to enter the message interface and press once to view
the saved messages. In order to do this, you must first turn ON the notifications in the application
and allow time to synchronize with the smart watch. Slide left to delete the current message.
Messages received on the phone can be displayed on the smart watch, but cannot be answered
from the watch. For incoming calls, they are displayed on the smart watch but cannot be heard
or answered on the watch.
5.2 Steps
You can view pedometer data on watch and APP. When watch is successfully paired with APP,
your sport data will automatically synchronize (or manually refresh) from watch to the APP,
including steps count, distance, calories and other parameters.
5.3 Sleep monitor
If you wear the watch when sleeping, you can check last night’s sleep time on the watch after
getting up the next morning. When watch is successfully paired with APP, the sleep data will be
automatically synchronized (or manually synchronized) to the APP. The watch will automatically
recognize and judge which is the sleep state. If you just get up briefly from bed, the sleep data
displayed on the watch is different from the actual data because the watch is still detecting sleep.
It is only when the watch completes detection that will show results of the whole night, and is
consistent with the actual data. It will be acceptable to have some errors with the actual data due
to different sleep states.
5.4 Heart rate monitor
When the heart rate data is empty, it displays “000Bpm”. Go to the heart rate icon, press once to
start the test. The data is displayed on the watch after the test. It is measured for 30 seconds and
the watch only keeps the last data. If you exit from the this function during the test, the data will
not be recorded.
5.5 Training
5.5.1 Training mode includes: Walking, Running, Cycling, Skipping, Badminton, Basketball,
Football.
5.5.2 Switch to the corresponding training icon: Press once to enter the corresponding exercise
mode. It will show data such as steps, distance, calories, heart rate and exercise duration. Slide
right to pause and exit.
To Next Page
Loading...
