MARIMEX Florida - Page 26

26
• Follow the Assembly instructions listed above, in order to build again at the next
pool season.The site for the pool must be before a new Assembly of the pool
again, checked andbalanced.
• If you want to drain the pool, locate the drain hole on the outer side of the wall of
the pool and remove the drain Cap.Connect a garden hose and stretch it to the
location where you want the water to drain.After you place the hose in the desi-
red location, you can open the stopper on the inner side ofthe swimming pool.
• Whena sucientdecrease in thelevels ofwaterremovefrompoolpartsfil-
terunitanddrainfromherall thewater.
• Once the water is out of the pool dropped wash with SOAP and warm water
pool and eventually wipe itwith a soft cotton cloth dry.Place theplug backinto
thedrainholeandreplace theCapof the discharge outlet.
• Remove the supporting frame.First separate the vertical struts from the T-co-
nnectors (releasing the spring fuse), then remove the bolts and separate thehori-
zontalbeamsfrom theT-connectors.Allpartscleananddry.
• Accessories,asare thesolarsails,sail cover,steps, etc.mustbebefore theentry
into storage ofcleanedanddried.
• Never leave your above ground pool outdoors if it isempty.
• Swimming pool,filtrationandotheraccessories toprotectagainstfrost.On
thedamage ofFrostisthe guaranteedoes not apply.

Link pool with ltration unit (Figure 5).
The listed parts are not included in the package pool.See the relevant instructions
for use of the filter unit.
Part name Part name
1 Pool wall 5 Return penetration
2 Water surface 6 Sucking penetration
3 Outside the pool 7 Return hose current direction
4 Inside the pool 8 Insulation hoses direction of water current
Contact
www.marimex.cz
Custome Centre
tel.: +420 261 222 111
e-mail:
zakaznickecentrum@marimex.cz