Marina-Speroni KS 801 P

Other manuals for Marina-Speroni KS 801 P

Operating Instructions65 pages

Questions and Answers

C
Charles TownsendAug 5, 2025
Why Marina-Speroni KS 801 P motor will not start?
- J
  John RodriguezAug 6, 2025
  The Marina-Speroni Water Pump motor might not start due to several reasons: * There may be no mains voltage, in which case you should check the voltage. * The pump impeller could be jammed. If so, dismantle the hydraulic section and check if the impeller rotates freely, then carefully reassemble. * The thermostat might be detached. In this case, dismantle the hydraulic section and check if the impeller rotates freely before carefully reassembling.
D
Daniel BerryAug 10, 2025
What to do if Marina-Speroni KS 801 P will not suck?
- A
  Ashley NguyenAug 10, 2025
  If your Marina-Speroni Water Pump isn't sucking, consider these potential causes and solutions: 1. Ensure the suction valve is submerged in water, at least 30 cm deep. 2. If the pump chamber is without water, pour water into the suction union. 3. Check the suction pipe to ensure it is airtight. 4. Clean the suction valve if it's not airtight. 5. Clean the suction rose if it's dirty. 6. Verify that the maximum suction lift hasn't been exceeded.
W
William FlemingAug 15, 2025
How to fix insufficient rate of flow in Marina-Speroni KS 801 P Water Pump?
- O
  oliviamcclureAug 16, 2025
  An insufficient flow rate in your Marina-Speroni Water Pump could be due to several factors: * A suction lift that is too high. Check the suction lift. * A dirty suction rose. Clean the suction rose. * A water level that falls quickly. Set the suction valve lower down. * A pump flow rate reduced by foreign bodies. Clean the pump and replace any worn parts.
P
Phillip IbarraAug 20, 2025
What to do if thermal cutout switches off Marina-Speroni KS 801 P?
- H
  Harold HansenAug 20, 2025
  If the thermal cutout is switching off your Marina-Speroni Water Pump, it's likely due to: * Motor overload. Eliminate any foreign bodies. * Excessive friction caused by foreign bodies. Eliminate any foreign bodies.
M
Michele HansenAug 26, 2025
Why won't my Marina-Speroni KS 801 P motor start?
- J
  Jenny LozanoAug 26, 2025
  If your Marina-Speroni Water Pump motor won't start, there could be a few reasons. First, check that there is mains voltage present. If there is no voltage, that's your problem. Another possibility is that the pump impeller is jammed. In this case, dismantle the hydraulic section and carefully check if the impeller rotates freely; then, reassemble with care. Finally, the thermostat might be detached.
M
Michael KlineAug 30, 2025
Why does the thermal cutout switch off my Marina-Speroni Water Pump?
- C
  Charles HuberAug 30, 2025
  If the thermal cutout is switching off your Marina-Speroni Water Pump, it could be due to motor overload. Try to eliminate any foreign bodies that may be causing the overload. Another possibility is excessive friction caused by foreign bodies. In this case, wait approximately 20 minutes for the thermal cutout switch to reset.