Need help?Do you have a question about the Marine Power Solutions MP-485 and is the answer not in the manual?
Provides helpful information for running and maintaining the marine diesel engine.
Alerts to possible bodily injury dangers and important information on safe operation of equipment.
Details proper fuel grade selection based on ambient temperature and preparation before filling.
Recommends 15W/40 lube oil for all ambient temperatures and filtering before use.
Advises using soft water, adding anti-freeze in cold weather, and heating water for difficult starts.
Explains the need for careful running-in of a new engine during the first 20 working hours.
Lists essential checks before starting the engine, including leakages, oil levels, and fuel.
Details the steps for starting the engine, including switching on the main switch and fan.
Outlines the correct procedure for shutting down the engine safely.
Advises on filling the fresh water cooling system with anti-freeze or draining it to prevent frost damage.
Provides instructions on how to drain the fresh water cooling system.
Details the process of draining the sea water system, including hose removal.
Details daily checks before starting the engine, focusing on oil level.
Outlines checks to be performed every 14 days, including gearbox oil, belt tension, and battery electrolyte.
Specifies service tasks for every 50 hours of operation, such as changing the oil filter.
Details service tasks for every 100 hours, including changing the oil filter and cleaning the intake silencer.
Covers inhibiting procedures for the engine while the boat is in water but not in use.
Discusses professional checks and repairs before carrying out long-term inhibiting.
Provides a schedule for inhibiting the engine while the boat is in water.
Details inhibiting procedures for fresh water and sea water cooled engines when the boat is on land.
Instructions for launching the boat, including greasing the stuffing box and venting it.
Troubleshooting steps for when the engine's start motor does not turn over or is defective.
Diagnosing issues when the engine turns over but fails to start or keeps stalling.
Addresses problems related to uneven running, often caused by fuel supply issues or compression loss.
Identifies potential causes for engine overheating, such as thermostat or impeller failure.
Troubleshooting when the engine runs smoothly but does not reach full revolutions.
Instructions for checking and adjusting engine and gearbox alignment using a thickness gauge.
General| Brand | Marine Power Solutions |
|---|---|
| Model | MP-485 |
| Category | Engine |
| Language | English |
To Next Page
