Need help?Do you have a question about the Marine Power 6.0 VVT and is the answer not in the manual?
Explains hazard signal words (Danger, Warning, Caution) and their meanings for safety.
Warns about CO hazards and recommends ventilation and inspections for safety.
Explains hydrolock, its causes, symptoms, and steps to prevent and remedy it.
Provides step-by-step instructions for starting EFI engines, including priming and bilge blower use.
Outlines break-in procedures and recommends a 25-hour service interval for oil and filter change.
Details the procedure for changing engine oil, including warming the engine and environmental warnings.
Lists diagnostic codes, their descriptions, MIL lamp, buzzer, and relevant comments for troubleshooting.
Identifies possible causes and remedies for an engine that fails to turn over.
Lists potential causes and solutions for an engine that cranks but does not start.
Provides troubleshooting steps for poor engine performance at high RPM.
Offers remedies for misfires and troubleshooting for rich/lean fuel systems.
Diagnoses and provides remedies for low/high oil pressure and excessive oil consumption.
Guides on verifying and troubleshooting overheating and water in engine cylinders.
Details adapter harness pinouts and provides a critical prestart checklist for safe operation.
General| Brand | Marine Power |
|---|---|
| Model | 6.0 VVT |
| Category | Engine |
| Language | English |
To Next Page
