B
r
i
d
g
e
M
a
t
e
™
b
y
M
a
r
i
n
e
T
e
c
h
n
o
l
o
g
i
e
s
For Ship Owners Concerned with Quality and Safety
MTSAL0048 v2.0
Bridge Mate Mini RadaScan Transponder Guide
Mounting
Charging
The Bridge Mate Mini RadaScan transponder is supplied with
a mounting bracket, which should always be tted so that the
transponder’s longest side is vertical, with the carrying handle at the
top.
To Mount the Transponder:
1. Hook the foot of the transponder underneath the knob on the
bottom of the bracket.
2. Rotate the transponder backwards until it is held in place against
the bracket by its magnet.
The unit must be fully charged before use. A full charge will take
approximately 3 hours.
To Charge the Transponder:
1. Switch the transponder OFF.
2. Unscrew the blue cap on the rear of the unit.
3. Connect 24 V DC, ideally using the supplied mains charger. (The
charge light on the front of the unit will turn amber.)
4. When the charge light turns green, disconnect the charger.
5. Replace the blue cap on the rear of the unit.
Magnet
Bracket
Knob
Mini Transponder – Side
Charge Light Meaning
Amber Charging
Green Fully charged – disconnect charger
Red Fault – return to Marine Technologies
Charging
Socket
Mini Transponder – Rear
To Next Page
Need help?
General