Marksman 67063c - Pre-Operation Setup and Usage; Component Mounting and Fitting; Grinding and Cutting Techniques

• Damaged switches are to be replaced in a customer service shop! Do not use electric tools that
cannot be switched on or off!
WARNING!
• For your own safety always use only the accessories and attachments specied in the operating
instructions or recommended or specified by the tool manufacturer!
• The use of accessories and attachments other than those specied in the operating instructions
can cause injuries! .
• Always have your tool repaired by certied technicians!
• This tool meets the relevant safety requirements!
• Repairs are to be carried out only by qualied technicians with original spare parts to avoid the
risk of injuries to the user caused by improper repairs!
• Hearing protection: In case of a sound pressure greater than 85.0 dB(A) wear hearing protection to
avoid damage to your hearing!
Special Safety Instructions
• Do not use the machine without the protective cover! Ensure that this is tted correctly!
• Check whether the mounting anges and the disk have been inserted correctly and are not
damaged’
• Ensure that the speed of the machine is high enough for the accessories. Allow a newly mounted
abrasive wheel to run without a load for at least thirty seconds! Please keep the safety instructions
in a safe place!
• Please ensure that the voltage of the mains power supply corresponds to that stated on the type
plate. The tool is equipped with a three pin plug!
• Only use a suitable extension cable when this is absolutely necessary! The use of an unsuitable
extension cable carries with it the danger of fire or an electric shock! If an extension cable has to
be used. ensure that it is correctly wired and in good condition!
• Your machine is double insulated. This means that two completely independent types of insulation
prevent you from coming into contact with live metal parts. This measure represents a high degree
of protection against an electric shock.
• When working with this machine it is advisable to use ear protection!
Before Initial Use
Mounting the Side Handle
During operation, keep one hand on the housing handle (5) and the other on the side handle (3). In
order to mount the side handle, screw it into the screw hole of the gear box (4) .
Correct Fitting of the Protective Device
Ensure that the protective cover (6) is tted correctly and that the xing screws have been tightened!
Before tightening the xing screws, turn the on and off switch (1) to the (0) position and remove the
mains plug!
Grinding and Surface Processing
In order to grind surfaces you should use a coarse abrasive disk with a sunken centre. You can use
abrasive disks with diameter of 125 mm. The maximum thickness is 6 mm. .
Cutting Metal
In order to cut rods, tubes and metal parts you should use a cutting-off wheel. You can use wheels
diameter of 125 mm. The maximum thickness in this case is 3 mm.