Caution
Ensure that all electric power is turned off before carrying out any
work. The electrical connections must be carried out by a qualified
electrician and must comply with the relevant local regulations. The
voltage and frequency of the power supply must comply with the fan's
specifications. The installation site must have an all-pole disconnecting
device with a contact opening width of at least 3 mm. The fans are
double-insulated and do not require a protective earth conductor.
If operated near a fireplace with chimney, care must be taken to
ensure that sufficient air can enter the room being ventilated. In
rooms with high humidity, installation must be done in accordance
with DIN/VDE 0100 T701. Use a soft brush or damp cloth to clean,
do not use any solvents.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall not
play with the appliance.
1. If the room where the fan is to be installed already contains a
stove, water heater or a gas fire, it is essential to ensure that
the air supply to the room is enough for both the fan and the
combustion appliance.
2. Please check the appliance that has not been damaged during
the transportation.
3. Check the electrical specifications label correspond to your
electrical supply carefully
4. The fan must be installed so that the blades are more than 2.3m
above the floor.
5. The fan is intended for mounting in indoors IP24 construction the
appliance.
6. The fan is to be installed on the wall.
7. Precautions must be taken to avoid the back-flow of gases into
open flue of gas or other fuel-burning appliance.
8. Cleaning and user maintenance shall not be made by children
without adults’ supervision.
Installation
1. Install the duct in the wall or ceiling ensuring there is a slight
gradient (
~
2°) towards the outside.
2. Ø 100, 125: Remove the cover from the casing by unscrewing
in an anti-clockwise direction.
Ø 150: Pull the cover forward and remove from the casing.
3. Ø 100, 125: Unscrew both screws and remove the middle
cover from the casing.
Ø 150: Unscrew screw (A) to remove the cover from the base plate.
ENGLISH
GB
Please read these assembly instructions carefully
before starting the installation.
7
To Next Page
