Maintenance
7.4
small particles of steel can become embedded in the sur-
face and will rust and will give the appearance that the
stainless itself is rusting.
Following these recommendations for the care and clean-
ing of your stainless steel will help insure that it will pro-
vide you with many years of service.
Chlorides
Today, chlorides are found in almost all soaps, deter-
gents, bleaches and cleansers; chlorides can be aggres-
sive to stainless steel. However, chlorides are very water
soluble. Therefore, THOROUGH RINSING of your bright
work after each use will help to keep your stainless look-
ing bright and shiny.
Scratches
Like many metallic surfaces, your stainless steel will
scratch. These are merely usage scratches and over time
will blend into the overall finish. Surface scratches can
be polished out with a polishing paste but this can be a
lengthy and work intense process.
7.2.6 Deck Hatches
Wax the rubber gaskets on all deck hatches with a car-
nauba wax to ensure gasket material does not stick to its
mating surface.
7.2.7 Acrylic and Plexiglass
Important: Do not use glass cleaning sprays, scouring
compounds, or solvents (such as acetone, gasoline, or
thinners) to clean acrylic or Plexiglass.
Following are guidelines for cleaning acrylic and Plexiglass
parts:
* Wash acrylic hatches, windows, and any other acrylic
compounds with mild soap and plenty of lukewarm
water.
* Use a clean, soft cloth.
* Apply only a light pressure when cleaning.
* Rinse with clear water, and blot dry with a damp cloth
or chamois.
7.2.8 Caulking
All deck fitting, bow rails, windows, hatches, etc, have
been caulked with the highest quality material to ensure
a waterproof joint with the boat. However, normal use will
flex the joint and eventually break down the seal.
Note: We recommend that all deck fittings, hatches, etc. be
caulked periodically to prevent damaging leaks from develop-
ing.
7.3 Mechanical Systems and Components
Refer to the manuals supplied by the boat component
manufacturers for their recommended periodic mainte-
nance. The manuals may indicate maintenance require-
ment, in addition to, the minimum maintenance tasks
listed in the following charts.
Note: In case of conflicts between the maintenance informa-
tion in this manual and the manuals supplied by the equipment
manufacturer, the equipment manuals take precedence.
7.3.1 Engine Gear Oil
See engine operating manual for recommended oils and
correct procedures for checking and replenishing oil.
7.3.2 Fuel Line Connections
Check all fuel line connections for leaks at least once a
year. Tighten as necessary.
Important: Be careful when tightening fittings. Over-tightening
can crack the flair fittings and flair nuts. Use only tube wrench-
es when tightening connections.
7.4 Periodic Maintenance
Proper and timely maintenance is the best insurance
you can buy for trouble free and pleasurable boating.
Included in this section are maintenance charts which
identify maintenance tasks and their frequency. Use the
charts as a checklist.
Following are specific maintenance tasks that you should
complete after the first 20 hours of operation:
*
To Next Page