English
Notes:
• Execute a Master Clear before you start learning (see the
method above).
• Make sure both remote controls have full batteries before
you start learning codes.
• Make sure you do not move the remote controls when
pressing the buttons.
• You cannot learn any commands for the following buttons:
Learn, Setup, Source buttons TV, VCR, CBL, etc, M1, M2,
M3, ShowView, Xanura Home or directly under the SHIFT
button.
• Experiment by learning two or three buttons first (to test
compatibility), before you learn all the buttons of your
original remote control.
• When the memory is full, one of the Mode LED's will
flash for 3 seconds. You cannot learn any codes when the
memory is full. You can, however, erase a mode with
codes you stored. You can only erase a full mode.
• By keeping the buttons for the existing remote control
pressed for a shorter period, there will be more memory
space left for learning codes on the Marmitek X-10
remote control. This also diminishes the chance that the
remote control learns the wrong codes.
• Experiment with the distance between the remote
controls if you have problems learning the codes.
• Some remote controls do not have the infrared LED in the
centre. Try experimenting by slightly moving the remote
controls (sideways or up/down).
• Tube lighting and bright sunlight can affect the procedure.
• Use the buttons L1, L2, L3 and L4 to learn the codes for
which the Marmitek X-10 remote control does not have a
proper button. If you encounter any problems when
learning the codes of buttons, erase the memory and
start again.
• You can only learn the codes for one original remote
control per mode, e.g. the codes for your DVD remote
control under the DVD button. With some combi devices
(e.g. a TV with built-in DVD player) you first have to learn
the TV functions in TV mode and then the DVD functions
in DVD mode. Learning the commands
1. Point your existing remote control at the Marmitek X-10
Remote (front to front). Keep a distance of 2,5 cm between
the remote controls.
2. Press the SETUP (8) button until one of the Mode LED's
stays lit. Release the SETUP (8) button.
3. Press the Mode button (TV, AUDIO, SAT, etc.) for the
device you want to learn. The LED will flash once.
4. Press the LEARN (24) button. The LED will flash once.
5. Press the button on the Marmitek X-10 remote you want
to store the new command under. The LED will blink once.
6. Depending on the type of remote control you have, you
can use one of two methods:
a. Press the button on the existing remote control
you want to learn. Keep this button pressed until
the LED on the Marmitek X-10 Remote
extinguishes. If the LED does not extinguish, but
starts flashing, you need to use method B. (If you
have just tried method A and want to try method B,
first repeat step 5).
b. Press the button on the existing remote control
you want to learn. Keep this button pressed as
28
To Next Page
Loading...
Need help?
General
