Marport M6 - Hydrophone Cabling; Passive Hydrophone

M6 - Mx computer System | V4 | Installation
Powering the Mx computer
About this task
Important: Only use recommended power supply MEAN WELL HEP-150-24 A. Marport
cannot not be held responsible for dysfunction of the system if recommended equipment is
not used.
Procedure
1.
Connect the power cable to the Mx computer.
2.
Connect MEAN WELL power supply to a power socket.
3.
Press on the Mx computer to switch it on.
Configuring Mac Mini Network
You need to change the IP address of the computer to be able to communicate with the Mx
computer.
About this task
Note: If you are moving from a system without the Mx computer, you need to switch off the
virtual machine:
•
Open VMware Fusion, then click Virtual Machine > Shut Down in the toolbar.
•
Cancel the automatic opening of VMware Fusion: Apple Menu > System Preferences >
Users & Groups > Login Items and remove VMware from the list.
Procedure
1.
From the top left corner of the screen, click Apple Menu > System Preferences > Network.
2.
If using an internet router, it must be connected to the port named Apple USB Ethernet
Adapter. In order to connect to the internet, make sure that Apple USB Ethernet Adapter
network is at the top of the list of networks, then is followed by Ethernet. If it is not at the top
of the list, click the tooth wheel icon at the bottom of the list and select Set Service Order.
| 19