Marquis spaTouch2 User Manual

spaTouch2™ Icon Driven Control Panel
User Interface and Programming Reference Manual
THE MAIN SCREEN
Spa Status
• Important information about spa operation can be seen on the Main Screen.
• Most features, including Set Temperature adjustment, may be accessed from this screen.
• The water temperature is displayed and the Set Temperature may be adjusted.
• Time-of-Day, Ozone and Filter status are available, along with other messages and alerts.
• The selected Temperature Range is indicated in the upper left corner.
• The Spa Equipment Control Icon will spin when a pump is in operation.
ICON Specifications
1. H = High Temperature Range
2. R = Ready Mode
3. F1 = Filter Cycle 1 Running
4. O3 = Ozone Running
5. C = Cleanup Cycle
6. Wi-Fi Signal Indicator
7. Flip Screen
8. Light Icon = Turns On/Off
9. Music Icon = Press To Enter
Music Screen
10. Message Waiting Indicator
11. Set Temperature Up
12. Spa Equipment Control Icon
13. Temperature Scale (F/C)
14. Current Water Temperature
15. Settings Icon
16. Heat Indicator
17. Decrease Set Temperature
Note: After 30 minutes* the display will automatically go into sleep mode, which turns the
display off. This is normal operation. Touch anywhere on the screen to “wake” the panel up.
*The actual number of minutes can be customized.
16
1

Marquis spaTouch2 Specifications

General

Compatibility	Marquis Spas
Display Type	LCD
Control Type	Touchscreen
Voltage	12V DC
Functions	Temperature control, jet control, lighting control, filtration control

Summary

THE MAIN SCREEN

Spa Status

Important information about spa operation can be seen on the Main Screen.

ICON Specifications

MAIN SCREEN DETAILS

Set Temperature

Details how to adjust the spa's set temperature using the panel controls.

THE SPA SCREEN

All Equipment Access

THE SETTINGS SCREEN

Programming Overview

SETTINGS SCREEN MODES

Heat Mode Comparison

Compares Ready and Rest modes, explaining their impact on heating and circulation.

FILL IT UP!

Preparation and Filling

Instructions on how to fill the spa and prepare it for operation.

Priming Mode Operation

Details the Priming Mode, its purpose, and how to operate pumps during this phase.

SPA BEHAVIOR

Pump Operation

Explains how to control spa pumps, including speed settings and timeouts.

Filtration and Ozone

Describes how the ozone generator works with the pump and filtration cycles.

Freeze Protection

ADJUSTING FILTRATION

Main Filtration Setup

Explains how to set filtration cycles using start times and durations.

THE UTILITIES SCREEN

Fault Log and GFCI Test

GFCI TEST FEATURE

Verifying Installation

Explains how to use the GFCI feature to verify proper spa installation and safety.

Forcing GFCI Test

Details how to manually initiate a GFCI trip test for troubleshooting or verification.

HEATER-RELATED MESSAGES

Water Flow and Heater Dryness Messages

Explains messages for low water flow, failed flow, and heater dryness conditions.

Heater Overheat and Troubleshooting Checks

Covers "Heater is too hot" message and general flow-related troubleshooting checks.

SENSOR-RELATED MESSAGES

Sensor Sync and Faults

SYSTEM-RELATED MESSAGES

Memory and Configuration Errors

Clock, GFCI, and Pump Errors

INSTALLATION AND SAFETY GUIDELINES

Basic Installation Requirements

CSA Compliance and Safety

Health and Safety Warnings