Mars RG Series - Page 21

Owner’s Manual - RG/RADS Series
21
Installation
Instructions
1 2 Long Screws
And Locknuts
Left
Right
Sill Angle
Bracket
Flat Head
Bolt
2 Each Required For
Each Support Bracket
Locknut
Mark
1 2 Long Screws
and Locknuts
L ocking S c rew
7/16"Locking Screw
and Washer
1
/
4
5
/
8
5
Side Louvers
Window Sash
Window Sill
Sill Angle Bracket
1 5
About1 / to1 /
4 8
Measure from
the cabinet edge.
3 4 (or1 )Long
Hex-head Screw
/2
of sill, and tight to bottom of cabinet as shown in
Fig.15A. Mark brackets at top level of sill and remove.
2. Assemble sill angle bracket to support brackets
at the marked position(Fig.15B).
Hand tighten, but allow for any changes later.
3. Install support brackets(with sill angle brackets
attached) to correct hole in bottom of cabinet as
shown in Fig.16.
4. Tighten all 6 bolts securely.
slide easily.
completely. Tighten locking screws on top
(Fig.17).
3. Close window behind top angle.
Fig.13 Fig.13B
Fig.15B
Fig.16
Fig.17
Fig.14
Fig.15A
5
Install Support Bracket
6
Extend Window Filler Panels
NOTE:
Check that air conditioner is tilted back about
1 "to 1 " (tilted about 3
° to 4°downward to the
outside). After proper installation, condensate should
normal use,correct the slope otherwise (Fig .14).