Owner’s Manual - RG/RADS Series
34
Troubleshooting
Tips
Water dripping
INSIDE when unit
is cooling.
Improper installation. Tilt air conditioner slightly to the outside to allow water drainage.
Refer to installation instructions - check with installer.
Water dripping
OUTSIDE when
unit is cooling.
Unit removing large quantity of moisture from humid room. This is normal during
excessively humid days.
Remote Sensing
Deactivating
Prematurely
(some models)
Remote control not located within range. Place remote control within 20 feet and pointed
in the general direction of the air conditioner unit.
Remote control signal obstructed. Remove obstruction.
Problem Solution
Room too cold
Set temperature too low. Increase set temperatur
To Next Page
Loading...
