1. Remove current hot date coder
1.1 Stop the line, power o the hot date
coder.
If using air-driven hot date coder, shut
o air supply and disconnect air pipe.
1.2 Remove packaging material from
the coder bracket area.
1.4 Using wider end of Allen key
a
from Marsh 241D box, remove the
2 bracket mounting screws.
1.5 Remove the bracket locking handle. 1.6 Remove existing platen rubber
from bracket, along with any platen
rubber clamps.
1.3 Undo connector on hot date coder.
© 2020 All rights reserved. We reserve the right to alter design and/or specifications without notice.
Marsh 241D Installation Guide
To Next Page
Need help?
General