Marshall Amplification CV503-WP - Camera Reset Functions; Reset Mode Selection; Exiting Setup Menu; Save and Exit Option

CV503-WP Manual
www.marshall-usa.com11 12
• ON: Set the camera setting to either “FACTORY” or “USER” of “CHANGE” menu. Make sure
to select the right mode from “CHANGE” before defaulting the camera.
• RESET MODE: Select the desired setting mode.
Select from USER or FACTORY using the LEFT or RIGHT button.
1. USER: Select “USER” if setting value user saved last is needed.
2. FACTORY: Select “FACTORY” if factory default setting is needed.
“FRAME RATE”, “CAM ID”, and “BAUDRATE” will note change.
• RESET: Reset the camera settings the factory defaults or user setting value.
WB CONTROL
AE CONTROL
DAY/NIGHT
IMAGE CONTROL
SPECIAL
SETUP
RESET
EXIT
RESET MODE
RESET
SAVE AS USER
RETURN
>
>
>
>
>
>
>
FACTORY
>
MENU RESET
9. RESET
Select RESET using the UP or DOWN buttons.
• SAVE: Exit the setup after saving the value changes.
WB CONTROL
AE CONTROL
DAY/NIGHT
IMAGE CONTROL
SPECIAL
SETUP
RESET
EXIT
>
>
>
>
>
>
>
MENU
10. EXIT
Select EXIT using the UP or DOWN button.
To RESET Camera to default settings
(1920x1080p30fps) power-cycle the camera
then use the following combo on OSD Joystick:
UP, DOWN, UP, DOWN, then push and HOLD
joystick in for 5 seconds then release.