GOLF TROLLEY INSTALLATION
Place the wheels over the axle
as shown. Please note the
difference between the left
and right, which are labeled
respectively.
Take out trolley from carton,
open battery and connect the same
color battery wire terminal to the
trolley, charge the battery before
operation, charging individually or
charging after installing are both
ok.
wire
Push the folding joint, make
it loose from the handle bar
hook, pull the aluminum tube
and make the upper and lower
joints fastened
Put the battery on the
holder
Install the scorecard
directly to the groove
of handle bar
Fold down the bag holder.
Revolve the clutch and slide
the wheel on the axle until
the “Quick Release” locks
into place
To Next Page
Loading...