Secure the battery
using the strap
provided.
Connect the power wire to the motor.
See the Maintenance section of this
manual for instructions on charging the
battery.
Turn the accelerator
to the on position.
Seize the handle and press the left
button for two seconds to turn on the
trolley.
Turn the speed knob in
clockwise and make the
speed from 1-9 numbers of
speeds.
When turns the knob in anticlockwise
to -1, -2,-3. and the LED is not lighted,
the retrograde resistance will increase,
and the brake function has achieved.
When the trolley is on running ,
LED is not flashing, press the
left button then the trolley will
stop and press it again and it
will continue working.
When it stops, select the time and
distance setting function by
pressing the button for once, twice
and three times to select 10M, 20M,
30M, LED will be flashing. Then
press the left button and it will keep
running as per the selected
distance..
It will stop after it finishes
all distance 10M,20M or
30M, if will return to the 3
setting if no operation
within 3 seconds.
To Next Page
Loading...