EasyManua.ls Logo

Marta MT-HP4230A - Cleaning and Maintenance; Error Messages; Specification

Marta MT-HP4230A
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8
Do not block the air intake or exhaust outlet.
Do not touch the top plate immediately after removing the pan or pan, as the top plate will still be very hot.
Do not use the device with a broken or damaged power cord. Contact a qualified specialist for inspection or repair, or contact the manufacturer.
Unplug the device from the wall outlet before cleaning or maintenance.
Allow the device to cool completely before cleaning.
Use only a mild detergent to remove dirt.
Do not immerse the device under running water to avoid malfunctions.
Before cooking, make sure that the ceramic dishes are clean, otherwise it may be difficult to wash off dirt and soot, and the dishes may discolor.
Do not use abrasive or aggressive cleaning agents for the device, as they can damage the stove as a result of a chemical reaction.
Do not use gasoline, thinner, hard cleaning brush or polishing powder to clean the cooker to avoid damaging the exterior finish.
Persons with pacemakers should be at least 60 cm away from the working stove.
Failure to follow these recommendations may result in electric shock or death.
The device is not intended for use by people with physical and mental disabilities who have no experience with this device. In such cases, the user must be previously instructed by the person responsible
for his safety.
CLEANING AND MAINTENANCE
Unplug the appliance from the power supply before cleaning.
Let the unit cool down completely.
Wipe external surfaces with a damp cloth with some washing-up liquid. Do not use abrasive detergents, any organic solvent or aggressive chemicals.
ERROR MESSAGES
During operation the following error messages can be displayed:
Errors
Check whether plug is swtiched on.
Check whether the electricity is cut off.
Warning Signal E0
Check whether the suitable pot is used.
Check whether the pot is put on the cooking plate
Warning Signal E1
Check whether the IGBT probe break off.
Warning Signal E2
Check whether the IGBT temperature reach very high.
Warning Signal E3
Check whether the voltage too high.>280V
Warning Signal E4
Check whether the voltage too low. <85V
Warning Signal E5
Check whether the main temperature sensor break off.
Warning Signal E6
Check whether the cooker dry burning.
Warning Signal E9
Check whether the errors on circuit.
SPECIFICATION
Power supply
Producer: COSMOS FAR VIEW INTERNATIONAL LIMITED-ROOM 701, 16
APT, LANE 165, RAINBOW NORTH STREET, NINGBO, CHINA
Made in China
220-240 V ~ 50/60Hz