The SE350 voltage regulator can be mounted in any plane, following are mounting dimensions.
FIGURE 1
FUSE
A 4 Amp, 250 V, 5 X 20 mm fuse is supplied with the regulator (Part A-527066).
It can be located on the rear face of the voltage regulator.
EXCITER POWER CIRCUIT
Connect the regulator wire F+ to the generator F+ or Fl field terminal.
Connect the regulator wire F- to the generator F- or F2 field terminal.
See Figure 2 for typical connection diagram
SENSING/POWER INPUT CIRCUIT
Input power and sensing is achieved through terminals 3 and 4.
The voltage input requirement of the SE350 is 190 to 240 Vac. See Figure 2
To Next Page
Loading...