How to fix DMX errors caused by Martin Jem Hazer Pro Fog Machine?
If your Martin Fog Machine causes DMX errors on other units when connected to a DMX system, the LINK menu may be set to SEND. Change the LINK menu setting to RECV.
What to do if my Martin Fog Machine appears dead?
If your Martin Fog Machine appears dead, there could be a couple of reasons. First, the mains fuse might have blown, so replace the fuse. Second, there might be no power at the AC cable inlet, so check the power cable and circuit breaker.
Why is my Martin Fog Machine not producing haze?
Your Martin Fog Machine might not be producing haze for several reasons: * The machine may not be at operating temperature. Wait until the '????' message is no longer shown. * '????' might be set to 0. Increase the setting. * A DMX signal might be present. Disconnect or turn off the DMX controller.
What to do if Martin Fog Machine causes DMX errors?
If your Martin Fog Machine causes DMX errors on other units when connected to a DMX system, it might be because the LINK menu is set to SEND. Set the LINK menu to RECV.
What to do if my Martin Fog Machine can't be fired by DMX controller?
If your Martin Fog Machine can be fired from the control panel or remote control, but not by a DMX controller: 1. The DMX address setting might be incorrect. 2. There may be a poor connection in the DMX line, so check the DMX cables and connections. 3. The LINK menu might be set to SEND, so set the LINK menu to RECV.
What to do if Martin Fog Machine has greasy haze output?
If you observe wet, greasy, non-uniform haze output, fluid drips or spits from the nozzle, or a very loud noise when firing the Martin Fog Machine, the cause may be incompatible haze fluid. Use approved fluid!
Why Martin Jem Hazer Pro fires from control panel but not DMX controller?
If your Martin Fog Machine can be activated from the control panel or remote but not by the DMX controller, there might be a few reasons: * The DMX address setting could be incorrect. * There might be a poor connection in the DMX line. Check the DMX cables and connections. * The LINK menu may be set to SEND. Set the LINK menu to RECV.
What to do if Martin Jem Hazer Pro won't produce haze?
If your Martin Fog Machine does not produce haze when set to RUN or when the remote haze switch is activated, consider these potential causes: * The machine may not be at operating temperature. Wait until the ready message is displayed. * The haze output may be set to 0. Increase the setting. * A DMX signal may be present. Disconnect or turn off the DMX controller.
Why Martin Fog Machine has greasy haze output?
If your Martin Fog Machine produces wet, greasy, non-uniform haze, drips fluid, or makes loud noises when firing, it might be due to incompatible haze fluid. Use only approved fluid!
Crucial safety measures for electrical hazards, including grounding and proper power sources.
Precautions against burns from hot surfaces and fire hazards from flammable output.
General safety guidelines to prevent physical harm, including slippery floors and supervision.
Guidelines for safe operation regarding respiratory health and ventilation.
Initial steps for setting up the machine, including location and fluid.
Instructions for operating the haze function and adjusting density.
Procedure for safely powering down the unit and its self-cleaning cycle.
Guidelines for placing and mounting the machine safely.
Electrical connection requirements and safety for AC power.
Detailed procedure for machine setup and fluid filling.
Pre-operation checks before applying power to ensure safety and readiness.
Steps to power on the haze machine and initiate heating.
Process for turning off the unit and its self-cleaning sequence.
Procedure to prepare the machine after fluid depletion to prevent pump damage.
Restoring default configuration settings to the machine.
General| Brand | Martin |
|---|---|
| Model | Jem Hazer Pro |
| Category | Fog Machine |
| Language | English |
To Next Page
