Need help?Do you have a question about the Martindale Electric HANDYPAT HPAT500 and is the answer not in the manual?
General| Continuity Test Current | 200 mA |
|---|---|
| Display | LCD |
| Battery Type | 6 x AA Batteries |
| Power Source | Battery |
| Appliance Class | Class I and Class II |
| Test Voltage | 500V |
| Insulation Test Voltage | 500V DC |
Instructions contain warnings for safe operation and maintenance, emphasizing understanding for injury prevention.
Measures for working with voltages exceeding 30V AC RMS, 42V AC peak, or 60V DC to avoid electric shock.
Product usage is intended for trained personnel familiar with portable appliance testing codes.
Recommends using protective gloves, goggles, and other safety measures when applicable.
Important warnings and cautions to observe before and during the use of the HPAT500.
Protection against accidental connection of mains supply voltage via the IEC socket.
Steps for testing IEC leads, covering Earth Continuity, Insulation, and wiring polarity checks.
Procedure for Class I tests including fuse check, Earth Continuity, and Insulation measurements.
Procedure for Class II tests, focusing on fuse check and Insulation measurement between live/neutral and metalwork.
Methodology for testing extension leads using the HPAT500's IEC Lead Test functionality.
To Next Page
