Need help?Do you have a question about the MartinLogan Dynamo 1000 and is the answer not in the manual?
General| Brand | MartinLogan |
|---|---|
| Model | Dynamo 1000 |
| Category | Subwoofer |
| Language | English |
Remove your new subwoofer from its packing.
Ideally, place the Dynamo 1000 in a corner near the front of the room.
Attach preamplifier/processor outputs to the signal input area on the rear panel.
Plug the Dynamo 1000 subwoofer into a wall outlet.
Set the level knob to medium and power switch to 'Auto On'.
Adjust your system and enjoy your new subwoofer.
Adjust bass level to avoid bloating; aim for unobtrusive, extended low end.
Phase setting depends on room and seating; experiment for best blending.
Crossover switch setting depends on connection mode (multi-channel or 2-channel).
Set LPF to ~70% of speaker's lowest frequency response for 2-channel mode.
Used for wireless connection setup and indicates status.
Indicates subwoofer status: blue for on, red for standby.
Located on the back panel; must be set to 'Auto On' for operation.
Connects to a 2-channel system with main speakers playing full range.
Connect preamplifier outputs to the Dynamo 1000's left/right inputs using RCA cables.
Set crossover to 'Variable (L&R In)' and LPF to ~70% of speaker's lowest frequency.
For home theater systems; uses LFE input for bass management by processor.
Connect processor's LFE output to the subwoofer's LFE input via RCA.
Set crossover to 'Bypass (LFE In)'; use processor for bass management.
Insert IEC power cord firmly into the subwoofer and then to an AC wall outlet.
Turn off/unplug, replace blown fuse with matching T 5A L 250V fuse.
Woofers require ~50 hours of break-in at moderate levels for optimal performance.
Establish wireless connection with SWT-1 transmitter by pressing sync buttons.
Place in a corner for most output; pull away from wall for smoother response.
Dealers offer tools and expertise for optimal subwoofer placement.
Experiment with positioning and settings over time for optimal room relationship.
Requires minimum three inches of open space between cabinet and front/back sides.
Convert to front-firing by changing the location of the attached feet.
Your room affects sonic experience; consider wave reflection and room shape.
Explains concepts like Standing Waves, Resonant Surfaces, and Resonant Cavities.
Suggests using ETC Spikes for tighter bass; provides installation instructions.
High quality speakers needed for stereo playback; play loudly, reproduce bass below 80 Hz.
Crucial for dialogue and front imaging; must be accurate and match front speakers.
Play down to 80 Hz; provide spatial effects; demands are increasing with new formats.
Essential for special effects bass; provides foundation for the entire system.
Covers cleaning, object placement, electronic interaction, power usage, and storm safety.
Addresses no output, muddy bass, and hums/unusual sounds with solutions.
Details frequency response, components, amplifier, impedance, weight, and dimensions.
Explains limited 90-day and 3-year warranty coverage and registration requirements.
Outlines servicing policies for products used in countries other than their original sale.
To Next Page
