Need help?Do you have a question about the MartinLogan Dynamo and is the answer not in the manual?
General| Brand | MartinLogan |
|---|---|
| Model | Dynamo |
| Category | Subwoofer |
| Language | English |
Connect preamplifier/processor outputs to the Dynamo's rear panel signal input area.
Plug the Dynamo subwoofer into a wall outlet after setting the level knob to O.
Set the level knob to a medium volume position and the power switch to 'Auto'.
Controls energy saving; 'Auto' turns unit on/off based on signal detection.
Setup for 2-channel systems with main speakers playing full range; LPF is active.
Setup for home theater/multi-channel systems using LFE input; processor handles bass management.
Use A/V processor for both 2-channel and LFE, allowing processor to manage bass.
Setup for 2-channel systems using amplifier's speaker outputs to connect to Dynamo.
Setup for 2-channel systems where Dynamo acts as an intermediary between preamp and amplifier.
Provides solutions for issues like 'No Output', 'Muddy Bass', and 'Hums or Unusual Sounds'.
To Next Page
