Need help?Do you have a question about the MartinLogan Source Speakers and is the answer not in the manual?
General| Brand | MartinLogan |
|---|---|
| Model | Source Speakers |
| Category | Speakers |
| Language | English |
Position speakers at least two feet from the back wall, angled toward the listening area.
Connect speakers to AC power for electrostatic cells and wall outlet.
Connect speaker cables to the rear panel signal input section for audio signal.
Connect external low-voltage power supplies to energize electrostatic panels.
Position speakers and listener for optimal imaging and stage width.
Refine speaker placement after break-in for optimal room acoustics.
Source speakers reproduce all frequencies above 470 Hz simultaneously.
Sophisticated conductive coating for uniform surface resistivity and durability.
Compact stator technology offering more open playable area for increased performance.
Proprietary process fuses stators and diaphragm for uniform tensioning.
Ultra-rigid aluminum alloy frame secures panel and provides sonic isolation.
Recommended 100-200 watts per channel, stable into varying impedance loads.
Check system power, speaker wires, interconnects, and other equipment.
Check power cord, outlet, dirt/dust, binding posts, and foreign substances on panel.
Check speaker wires for correct polarity and binding posts for dirt/tightness.
Technical details including frequency response, dispersion, sensitivity, impedance, etc.
To Next Page