③ Confirm whether oil drain handle is at the stop position.
④Pour oil into Oil tank.
・Pour oil at the specified amount of oil.
※ There is a mark of the oil amount inside of Oil tank. The center of the mark is the sp
ecified oil amount.
When oil is heated, the volume expands to the top of the mark.
・Heater cover mark is as following below.
Top mark: The upper limited of oil (Do not pour oil more than this.)
Middle mark: Appropriate amount of oil.
Bottom mark: The lower limited of oil.
（Be sure to add oil when it is less than this.）
⑤ Ventilate with ventilation system.
⑥ Turn on the main power (Hand switch).
●Confirm whether there is no water left before putting oil in Oil tank.
It is very dangerous that you may have a risk of burn injury because the
oil may spit on you when remaining water is boiled while in use.
●Always use cold oil to pour into the oil tank.
Pouring hot oil into Oil tank is very dangerous because it may cause burn injury.
●Use lard heating（Melt function）in case of using a solid oil such as lard.
（refer to 2-4 other usage）
To Next Page
Loading...