Insert Wine Bottles
The wine rack pull-out shelf holds four (4) bottles. See
Figure 4 for typical wine bottle orientation. The wine rack
should be located at the top part of the interior cabinet.
Place the remaining shelves as desired (see Figure 5).
Loading Tips and Suggestions
The two (2) wire racks are for general beverage storage,
such as beer and soft drinks.
You may store magnums and other large bottles on any
of the racks (except for the top rack) by removing the rack
directly above them.
Keep wines that you plan to use for everyday drinking and
entertaining on the front half of the racks where labels are
completely visible. Place wines for aging or longer term
storing in the rear.
Pull-out Racks
The pull-out wine and wire racks may be pulled out ap-
proximately seven (7) inches to facilitate adding or remov-
ing bottles. Do NOT lean on or press down heavily on the
wine shelf. Doing so may damage the shelf and the wine
bottles stored on it. Pull the wine rack out gently and care-
fully to minimize unsettling your wine collection. AVOID
pulling out more than one rack at any time to maintain
stability.
The bottles on the top rack directly under the light will be
exposed to a slightly higher temperature when the light is
on. Position your wines accordingly and REMEMBER TO
TURN OFF THE LIGHT WHEN IT IS NO LONGER NEEDED.
Single Bottle Racks
Since bottles are not stacked on top of each other, you can
easily view and access your inventory without disturbing
other bottles (see Figure 6).
3BARM BEVERAGE AND WINE REFRIGERATOR FEATURES
16
Figure 5
Figure 6
Front Bottles (Necks Facing Rear)
Rear Bottles (Necks Facing Front)
Figure 4
Wine shelf
locate at top
of cabinet
Wire shelves
locate as
desired
To Next Page
Loading...
