Need help?Do you have a question about the Marzocchi Jr T and is the answer not in the manual?
General guidelines for fork maintenance and overhaul procedures.
Steps for attaching the fork to the bicycle frame, including component removal and bolt tightening.
Adjusting the fork's spring tension using the top knob for rider preference.
Modifying the rebound damping via an internal adjuster in the cartridge rod.
Procedure to remove and replace the fork's internal spring and related components.
Steps for draining oil and replacing guide bushings and seals in the fork leg.
Process for removing and replacing the cartridge rod, rebound spring, and seal ring.
How to check and replace the valve unit within the stanchion tube.
Instructions for installing the guide bushing and ensuring it is properly seated in the slider.
Reassembling the valve unit components, cartridge rod, seal ring, and rebound spring.
Procedure for fitting the stanchion tube into the oil seal and slider, checking the cartridge rod.
Steps for filling the fork legs with the correct amount of oil and checking the oil level.
Installing the spring and the preload cap assembly onto the stanchion tube.
General| Intended Use | Downhill |
|---|---|
| Travel | 130 mm |
| Spring Type | Coil |
| Damper | Open Bath |
| Stanchion Diameter | 30 mm |
| Type | Suspension Fork |
| Brake Compatibility | Disc |
| Adjustments | Preload |
| Wheel Size | 26 inches |
| Steerer Tube Diameter | 1 1/8 inches |
To Next Page