3
78
Instruments and gauges
TRIP screen page
The Trip screen page is recalled by
pressing the MODE (J) button. Each
TRIP screen page (A or B) is timed, i.e. it
is displayed for a maximum of 10
seconds, after which the screen
previously active is restored.
When the TRIP A or TRIP B feature is
active, the following information is
viewed on the display:
– travelled distance (km - miles)
– average fuel consumption (km/L –
mpg)
– average travelling speed (km/h -
mph)
– trip time (hh:mm)
– fuel range (km - miles)
The unit of measurement can be set
through the set up menu of the Multi
Media System.
Tyre pressure screen page
If the vehicle is equipped with the tyre
pressure monitoring system (optional),
pressing the MODE (J) button the user
will display information about the
"Tyre Pressure".
This screen page is displayed for 10
seconds and, in normal conditions, it
will appear as shown in figure 1
– furthermore, the system
acknowledges the following
conditions:
– system temporarily not active (es.
external radio interference)
– system not calibrated (e.g. tyre
replaced)
– system failure
– system not active (if it is disabled by
the diagnostics system)
– low pressure or puncture in front LH,
front RH tyres or rear LH and rear RH
tyres
– low pressure or puncture in
unidentified tyre.
The system can be calibrated by
pressing button M, on the front dome
light fixture. The initialisation of the
procedure is indicated on the display
by the message “Calibration
activated”.
For more information, please see the
“Tyre pressure monitoring system”
chapter on page 47.
1
M
M139_UM_ing.book Page 78 Friday, September 5, 2008 8:19 AM
To Next Page
Loading...
