Set up the hub
Place the hub on top of a nightstand, side table or a cabinet in the same room as the
baby’s crib to ensure a strong connection.
Attach USB Cable to Hub
Plug the hub into a wall socket.
Use the same app you downloaded for pairing the sensor.
Plug the hub power cable
into the back of the hub.
Plug the other end of the hub power
cable into the 5W power adapter.
5W
Pair the hub to the app
Note: The top of the
Hub has a button here
used to silence alerts.
Cleaning Sensor and Boot
Remove the sensor and place just the boot (and the straps if desired) in the washing machine.
Remove Sensor
Do not put the sensor
in the washing machine
To remove the sensor, push it from the
opening at the bottom of the boot.
Boot and sensor maintenance
Sensor
Zone
Top Sensor
Bottom Sensor
Strap Tightness
The sensor strap should sit
flush against the top of the
foot, with no gap.
The ankle strap should be
snug but not tight.
Boot Sizing (Using Small Boot As Example)
IMPORTANT NOTE
Make sure all sensors are making good contact with
the baby’s skin to ensure correct measurement.
Dampen a cloth with water to wipe the
components of the Stork System (sensor
is shown in the example). Bleach wipes or
70% isopropyl alcohol can also be used.
Do not use household cleaning agents.
OWNER’S MANUAL
Refer to the online manual for other functions,
information, and operation details.
masimostork.com/vitals-user-manual
OK
OK for toes to
overhang - boot
DOES NOT
fit like
a typical shoe.
To Previous Page
Loading...