vitals
Medium Boot
(Size 4 Strap
Pre-Attached)
Hub Power Cable
Size 1 and
Size 2 Straps
Sensor Magnetic
Charge Cable
and Cable Clip
2 X 5W
Charge Adapters
Sensor
Hub
Small Boot
(Size 3 Strap
Pre-Attached)
What’s in the box?
© 2023 Masimo. All rights reserved. 304488/11992A-0523
Quick Start Guide
Too long
(Velcro not on fabric)
Perfect! Too short
Apply Boot to Either Foot
Check the Strap Length
Insert the sensor at
an angle, toe end first.
Insert Sensor Into Boot
Press down to secure the
sensor. The sensor should
sit flush in the boot.
Not intended for use as a medical device or
to replace a medical device. Do not use it to
diagnose, cure, treat, alleviate, or prevent
any disease or health condition.
Ankle
Longer strap
Sensor
Shorter strap
Sensor
Shorter strap
Remove sizes 1 and 2
from paper sleeve.
Preattached on medium boot
Preattached on small boot
In paper sleeve
In paper sleeve
SIZE
4
SIZE
3
SIZE
2
SIZE
1
Slide on
Add straps to sensor and boot
Size 1 strap
(for newborn foot)
Slide on
Charge the sensor
Plug the Sensor Magnetic Charge
Cable into the 5W power adapter.
Connect the magnetic end of the cable to the
sensor. Fully charge the sensor before use.
Peel and stick the cable clip
to secure the sensor charge cable.
The sensor is fully charged
when the LED turns white.
Pair the sensor to the app
The app screens shown in this document might
differ from the actual ones displayed in the app.
Download the Stork app and follow instructions.
To Next Page
Need help?
General
