D-11
Lubricate rear axles
Service interval: Yearly
1. Remove the ignition key and disconnect the spark plug
wires while working on the unit. Engage the parking brake.
If desired, remove the catcher assembly.
2. Block the front tires. Using a floor jack or chain hoist,
carefully elevate the rear of the tractor 2,5-5 cm (1"-2") off
the ground and support with jackstands.
If using an overhead hoist to lift the unit, lift using
only the back plate or catcher support arms.
For overall unit stability during service, do not
raise rear of the tractor higher than required for
wheel removal.
3. Pry the hub cap (G) off using a small screw driver or pliers.
4. Remove the retaining ring (F), hub cap retainer (E) and
wheel (D).
5. Remove the large washers (B), spacer (C) and key (A).
6. Lubricate the axle shaft with anti-seize compound or
lithium grease.
7. Reinstall components in reverse order of disassembly.
Be sure the key (A) is installed in the axle key-way.
8. Lower the tractor.
A
B
D
E
C
F
G
B
To Next Page
Loading...
