To Next PageTo Next Page
Need help?Do you have a question about the MASSEY FERGUSON 2650 and is the answer not in the manual?
General| Engine Type | Diesel |
|---|---|
| Fuel Type | Diesel |
| Type | Agricultural Tractor |
| Drive | 4x2 2WD |
| PTO Speed | 540/1000 rpm |
Explains the purpose and importance of the workshop manual for dealer service.
Details the structure and organization of the manual's modules, sections, and subsections.
Provides essential safety rules and precautions for maintenance work.
Outlines best practices for disassembly, cleaning, part handling, and using correct tools.
Presents tables with recommended torque values for various bolt and nut sizes.
Provides conversion tables for various units of measurement and explains SI prefixes.
Details Loctite products for threadlocking, sealing, and fastening applications.
Lists components and their specified Massey Ferguson paint colors.
Outlines AGCO's commitment to environmental preservation and sustainable practices.
Explains regulations and procedures for the proper recycling of used batteries.
Details engine features, power, torque, and specifications for different models.
Lists battery, alternator, starter motor, and lighting specifications.
Describes clutch type, play, and disc diameter for different models.
Explains the characteristics of various gearbox types (8x2, 8x8, 12x4) and creeper options.
Provides a chart of theoretical travel speeds based on gear and tire size.
Details axle type, reduction ratios, load capacity, and differential lock.
Covers front axle types (2WD, 4WD), adjustments, and load capacities.
Describes the brake service, drive type, disc material, and parking brake mechanism.
Specifies lift capacity, pump type, pressure, output, and filtration.
Details steering system operation, pressure, flow, and filtering.
Describes control valve type, flow rates, relief valve, and available valve types.
Outlines PTO types (Dependent, IPTO), control, speed, and shaft specifications.
Lists shipping and balasted weights for cab and footstep versions.
Details capacities for engine oil, cooling system, fuel tank, transmission, and axles.
Provides specifications for drawbar static load and PTO shaft positioning.
Describes cab features, compressor, refrigerant, condenser, and air filter.
Specifies torque values for front and rear wheel bolts/nuts.
Presents overall dimensions, weights, wheel sizes, and turning circles for different models.
Explains the steps to separate the engine from the transmission.
Explains the steps to separate the transmission from the rear axle.
Covers procedures related to sheet metal and canopy removal or installation.
Details separation procedures for tractors equipped with cabins.
Details the process for separating the front axle from the engine.
