23. Proceed with radiator air purging in a well ventilated area. Ensure the cab heater vents are
opened fully, and the fan switch is turned to the on position. Open the radiator cap, start the
engine and run at a high throttle position to encourage the thermostat to open and close
repeatedly. Re-fill the radiator as necessary to top up radiator coolant.
24. Take the left rear tractor flasher, steel mounting bracket, factory bolts, and attach to the
outer mount tab on the tractor cab. Route the wiring harness down through the hole in the
rear fender and re-connect.
25. Take the right rear tractor flasher, steel mounting bracket, factory bolts, and attach to the
outer mount tab on the tractor cab. Route the wiring harness down through the hole in the
rear fender and re-connect. Ensure work light is also re-connected if equipped.
June 2021© Massey GC1705 ROPS Cab Installation Manual
To Next Page
Loading...
Need help?
General
