1 - 22
INTRODUCTION
Working in safety
B - Tools
Makeshift, inadequate or defective tools may cause
faults or accidents. Never use the wrong tools since
such action could cause injuries and spoil the finished
job.
Always use the special tools recommended by the
manufacturer when disassembly, overhauling and re-
assembly the various parts of a tractor. (Fig. 6-1)
-Use of specific tools will reduce the effort and time
required for the job and, consequently, the cost. You
will also be certain that the work has been correctly
done.
Never use:
- A hammer with a loose head or cracked handle.
- Pincers or pieces of iron instead of a hammer;
drill bits or bolts instead of pin drivers.
- Worn or welded wrenches.
- A steel hammer to tap bearings or stress relieved
components (use one made of bronze or brass).
The engine and gearbox and the front and rear tran-
smissions must be split for certain jobs on the tractor
components. This operation is facilitated and made
safer by use of the special divider kit (Fig.7-1).
When lifting weights, make sure that the chains, lifting
brackets, hooks, cables or ropes comply with CE stan-
dards.
Unless different indications are given, an adjustable
bracket must be used when particularly heavy parts
are removed.
All chains and cables must be parallel to each other
and as near to the vertical as possible, depending on
the component being lifted.
C - First Aid
Mechanics are exposed to various risks at work.
If anyone should be injured, use sterile materials and
disinfectants for first aid purposes. These materials
should be kept in the first-aid box, equipped in com-
pliance with the laws in force.
Plug used to mount the bushing on the differential housing.
Plug used to insert the external rings on the taper bearings of the
rear differential
Puller for the normal and fast upper shaft mounted on the differential
housing
Plug used to mount the needle bearing on the slow reduction range
gear shaft
Fig.9-1
Fig.10-1
Fig.11-1
To Next Page
Loading...
