Master & Dynamic MA770 - Audio Input and Stereo Pairing; Using Bluetooth, Analog, and Optical; Setting Up a Stereo Pair

15
EN
14
EN SETTING UP A STEREO PAIR
To create a stereo pair between two MA770 speakers, first make
sure they are both connected to the same WiFi network. Now hold
down the -VOL and PAUSE keys on the left speaker for 4 seconds.
Once the lights on the SOURCE key quickly flash quickly release
the keys. Next, hold down the +VOL and PAUSE keys on the right
speaker for 4 seconds. Similarly, once the lights on the SOURCE key
flash, you can release. When the lights on each speaker remain on,
you've successfully created a stereo pair. If the pairing has failed,
the lights on each speaker will quickly flash and then turn off.
USING BLUETOOTH, ANALOG AND OPTICAL
To play music via Bluetooth, first make the the light next to BT on
the control panel is lit. Next, make sure Bluetooth is turned enabled
on your mobile device and then select the speaker as the device. Tap
Play within the music streaming application.
Each speaker has an Auxiliary Analog Audio and TOSLINK Optical
Audio input. Your speaker is compatible with devices that have
similar auxiliary and optical outputs.
L
0:04
R
- VOL + VOL PAUSE SOURCE
CAST
BT
AUX
OPT
- VOL + VOL PAUSES OURCE
CAST
BT
AUX
OPT
0:04
RL
1
2