Master Audio
CS Series. Version 1.0 Mar14 6
• PIN 1 and PIN2 are connected internally and are positive (+)
• PIN3 and PIN4 are connected internally and are negative (-)
Screw the hold-down screws on the connector until tight, using a small
screwdriver. You can connect the speakers in the following possible layouts:
• Wiring in parallel: connect the wire pair of the subsequent speaker
(SPK2) to PIN 2 and PIN3. When one input connector is removed,
subsequent speakers will remain connected
• Daisy-chaining: connect the wire pair of the subsequent speaker
(SPK2) to PIN 1 and PIN4. When one input connector is removed,
subsequent speakers will be disconnected
Fig.4. CS6MC/T wire connection
To Next Page
Loading...
