EasyManua.ls Logo

Master equipment TP15140 User Manual

Master equipment TP15140
3 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
SAVE THESE INSTRUCTIONS • IMPORTANT SAFEGUARDS
Basic safety instructions should be followed when using electrical appliances, including the following:
READ ALL INSTRUCTIONS BEFORE USING. DESIGNED FOR ANIMAL USE ONLY.
OPERATING INSTRUCTIONS:
This table is designed for use on alternating current 120V only. This grooming table also has a polarized plug (one blade is wider
than the other). As an important safety feature, this plug is intended to fit into a polarized outlet only one way. If the plug does not
fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not attempt
to modify the plug in any way. This table is also designed with an automatic shut-off. Motor, transformer, and cord are all UL
Approved. We recommend that this table be used with a surge protector at all times.
TABLE OPERATION:
1. Before use, make sure table is level by turning leveling feet under each base leg. Plug cord into any standard
110/120 wall outlet.
2. This grooming table is equipped with identical up and down control pedals located on each side of the table base.
3. The pedal on your right as you are facing the table moves the table up; the pedal on your left moves the table down.
4. To reduce strain and unnecessary lifting of large animals, it is recommended to lower the table to the minimum
height and let animal step up onto table before positioning table at desired height for grooming.
5. Once animal is positioned on table, place the grooming loop that is attached to grooming arm around
animal’s neck and adjust loop to fit comfortably.
ASSEMBLY OF FOLDABLE GROOMING ARM:
1. Place arm support base on edge of grooming table and tighten bolt clamp to secure to tabletop.
2. Loosen height adjustment knobs and slide grooming arm post at both top and bottom until it is at desired height.
Tighten knobs to lock into place.
3. Swing foldable arm over post until it is positioned over table perpendicular to grooming post.
4. Attach grooming loop to eye-screw at top of arm.
5. Fold arm back against post when not in use.
Electric Grooming
Table With
Foldable Arm
Non-skid vinyl surface
Steel construction
Leg levelers for all four legs
Down
Up
Dual foot pedal
controls on each side
Telescoping arm folds
for easy storage
Height adjusts
from 20" to 44"
Lifts up to
180 lbs.
• Lifts up to 180 lbs
• 41"L x 24"W x 3" thick tabletop
• Height adjusts from 20" to 44"
• Heavy-duty steel construction
• Durable, rust-resistant, powder-coated finish
• Convenient hooks for hanging tools
• Ultra quiet operation
Page 1 of 3
TP15140 elec. grooming table inst 1/12/06 11:32 AM Page 1
Question and Answer IconNeed help?

Do you have a question about the Master equipment TP15140 and is the answer not in the manual?

Master equipment TP15140 Specifications

General IconGeneral
BrandMaster equipment
ModelTP15140
CategoryPet Care Product
LanguageEnglish

Summary

OPERATING INSTRUCTIONS

TABLE OPERATION

Steps for operating the grooming table, including leveling, plugging in, and using pedals.

ASSEMBLY OF FOLDABLE GROOMING ARM

CARE & MAINTENANCE

TROUBLESHOOTING

Table Does Not Turn On

Steps to check if the table is plugged in, control box connections, and transformer.

Table Fails to Raise or Lower

Steps to check transmission cable or replace the transmission shaft if the table fails to move.

SAFETY PRECAUTIONS AND WARRANTY

CAUTION AND WARNINGS

Important safety precautions and general warnings to reduce risk of injury or damage.

LIMITED WARRANTY

Warranty information for the grooming table, covering defects and exclusions.