Need help?Do you have a question about the Master-force ANGLED FINISH NAILER and is the answer not in the manual?
General| Power Source | Pneumatic |
|---|---|
| Magazine Capacity | up to 100 nails |
| Nail Gauge | 16 gauge |
| Nail Length | 1-1/4 inch to 2-1/2 inch |
| Operating Pressure | 70-120 PSI |
Specifies the required pressure regulator range for safe operation and maximum allowable air pressure.
Advises against exceeding maximum operating pressure to prevent wear and maintain driving power.
Explains the importance of a filter for performance and wear reduction, and its maintenance.
Describes tool-free adjustments for exhaust, depth, and jam release, enhancing user convenience.
Explains the selectable trigger allowing choice between contact or sequential actuation modes.
Details the rear-loading magazine, lightweight magnesium housing, and swivel connector benefits.
Highlights features like no-mar tips, LED work-light, and push-button air blower valve.
Details single and rapid fastener placement using the contact trip and trigger mechanism.
Explains operation for sequential trip models using contact trip and trigger in sequence.
Provides steps to verify the correct functioning of the contact trip operation mode.
Provides steps to verify the correct functioning of the sequential trip operation mode.
Recommends using Masterforce replacement parts for optimal performance and longevity.
Guidance on cleaning and lubricating internal parts during assembly or repair.
Emphasizes the importance of adequate air volume and pressure for tool performance.
Details proper lubrication methods using non-detergent oil for best performance and reduced wear.
Advises on preventing freezing and potential tool failure in cold weather conditions.
Offers a full refund if the tool is not satisfactory within ninety days of purchase.
Covers defects in material or workmanship for three years, including repair or replacement.
To Next Page