Master Quality Power MC1018 - Specific Safety Rules for Wood Lathe; Assembly and Installation Mandate; Lathe Operation Safety Guidelines

9. ALWAYS remove the power cord plug from the electrical outlet when making
adjustments, changing paets , cleaning or working on tool.
10. AVOID ACClDENTAh START-UPS. Make sure that the power switch is in the
"OFF" position before plugging in the power cord.
1 1. REMOVE ADJUSTING TOOLS. ALWAYS MAKE SURE all tools are removed from
the wood lathe befare turning it on.
t 2. NEVER LEAVE A RUNNING TOOL UNATTENDED. Turn the power switch to
bOFP'. DO NOT leave tool until it has come to a complete stop.
13. NEVER STAND ON A TOOL. Serious injury could result if the tool tins or is
accidentally hit 00 MOT store anything above or near the tool.
14. DON T OVERREACH. Keep proper footing and baiance at all times. Wear oil-
resistant rubber-soled footwear. Keep floor clear of oil scrap and other debris.
15. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working
order. Follow instructions for lubricating and changing accessories.
16. CHECK DAMAGED PARTS. Check for alignment of moving parts, binding of
moving parts, breakage of parts, improper mounting or any other conditions that
may affect the tools operation. Any part that is damaged should be properly repaired
or replaced before use.
17. MAKE WORKSHOP CHILDPROOF. Use padlocks, master switches, and
ALWAYS remove starter keys.
18. DO NOT operate tool if you are under the influence of any drugs, alcohol or
medication that could affect your ability to use the tool properly.
t 9. WARNING. Dust penetrated from certain materials can be hazardous to your
health. Always operate lathe in a well-ventilated area and provice for proper dust
removal. Use dust collection systems whenever possible.
ID Specific safety rules for the wood lathe
WARNING: DO NOT OPERATE YOUR WOOD LATHE UMlL If IS COMPLETELY
ASSEMSLED AND INSTALLED ACCORDING f 0 THE INSTRUCTIONS.
1. For your own safety, read the entire instruction manual before operating the lathe.
2. ALWAYS wear eye protection.
3. Do not wear gloves, necktie, or loose clothing,
4. Tghten all locks before operating.
5. Do not mount a split workpiece.