To Next PageTo Next Page
Need help?Do you have a question about the Master B70 and is the answer not in the manual?
Crucial safety rules for operating and maintaining the heater to prevent injury or fire.
Step-by-step instructions for assembling the wheels and handles on specific heater models.
Specifies approved fuels (kerosene, paraffin) and warns against flammable alternatives.
Details minimum fresh air opening requirements for safe operation and CO prevention.
Outlines the heater's voltage, frequency, and power cord wiring color code.
Step-by-step guide on how to safely start the heater, including fuel and electrical connections.
Instructions for safely shutting down and restarting the heater unit.
Detailed steps for draining and preparing the heater for storage, including fuel handling.
Troubleshooting steps for heaters that ignite but shut off shortly after due to flame-out control issues.
Diagnosing issues when the heater motor runs but ignition fails, covering pressure, spark plug, and filters.
Resolving problems where the motor fails to start or the fan operates slowly or not at all.
Instructions for safely removing the upper shell to access internal heater components.
Procedure for cleaning or replacing the fuel filter on specific heater models.
Steps to service the fuel filter for the 90,000 BTU/Hr heater model.
Guide to cleaning or replacing the fuel filter for the 150,000 BTU/Hr heater model.
Procedure for cleaning, gapping, and replacing the spark plug on the 30,000 BTU/Hr model.
Steps to clean, gap, and replace the spark plug on higher BTU/Hr models.
Instructions for cleaning or replacing air output, air intake, and lint filters.
Guide to adjusting the pump pressure using a pressure gauge for optimal performance.
Procedure for cleaning or replacing the nozzle assembly on the 30,000 BTU/Hr heater.
Steps to remove, clean, and reinstall the nozzle on 70/90,000 BTU/Hr models.
Procedure for servicing the nozzle on the 150,000 BTU/Hr heater model.
Instructions for addressing a binding pump rotor, including cleaning and gap adjustment.
Procedure for removing, cleaning, and reinstalling the fan from the motor shaft.
Detailed technical data including output rating, fuel consumption, and electric requirements.
Details the terms, conditions, and limitations of the manufacturer's warranty for the equipment.
Information on how to contact the manufacturer for warranty service and obtain a service manual.
General
