Master EC-200 User Manual

2
www.masterappliance.com
Important Safety Instructions
The EC-200 is a lightweight, ergonomic heat gun with variable
temperature settings between 110°F and 930°F. It is well-suited for
a wide variety of DIY, hobbyist and homeowner projects, as well as
automotive and industrial applications.
To reduce the risk of re or explosion, electric shock or injury
to persons, read and understand all instructions included in
this manual. Be familiar with the controls and proper usage of
equipment.
• Withaheatgun,aswithallotherheat
tools, keep a re extinguisher handy
and observe all sensible re precautions.
• Keepguninconstantmotion. Do not
stop or dwell in one spot.
• Useextremecautioniftheotherside
of the material being scraped is not
accessible, such as house siding. The
hidden side could catch re if it becomes
too hot. Some buildings contain highly
ammable materials behind siding, oors,
facia, soffit boards and other panels.
Check these areas before applying heat
and do not use a heat tool if ammable
materials are present or if you are unsure
of the hidden material.
• Donotusenearsurfaceswithcracks
or near metal pipes or ashing. Heat
may be conducted behind the work
surface and ignite hidden material. The
ignition of hidden materials may not be
readily apparent and can result in property
damage and injury.
• Donotuseelectrictoolinthepresence
of ammable liquids or gases.
• Donotusenearcombustiblematerials
such as dry grass, leaves and paper which
can scorch and catch re.
IMPORTANTSAFETYINSTRUCTION
 WARNINGThis heat gun produces
extreme high temperatures (as high as
930°F). It must be used with caution to
prevent combustible materials from igniting.
Indicates a hazardous situation, if not avoided could result in death or serious injury.
ImportantSafetyInformation•Readallsafetyinformationbeforeoperating
equipment. Save these instructions.
• Thenozzlebecomesveryhot. Do not
lay the heat gun on ammable surfaces
when operating the gun or immediately
after shutting the gun off. Always set the
heat gun on a at surface so that the
nozzle tip is directed upward and away
from the supporting surface.
• Donottouchthenozzle until the tool has
cooled.
• Donotusethegunasahairdryer.
• Toolsandpaintscrapingsbecomevery
hot. To avoid burns, use work gloves
when scraping.
• Alwaystreatthehotairunitswiththe
same respect as an open ame.
• Donotworkinwetareasorexposethe
heat gun to rain.
• Guardagainstelectricshockby
preventing body contact with grounded
surfaces such as pipes, radiators, ranges,
aluminum ladders or other grounded
devices.
• Donotabusetheelectriccord. Never
carry the heat gun by the cord or yank on
the cord to disconnect it from the power
supply. Keep the electric cord away from
heat, oil and sharp edges.
• Useextensioncordratedforoutdoor
use. If an extension cord is damaged or
otherwise unsuitable for use, replace it
with a new cord.
• Notintendedforusebyyoungchildren
or inrm persons without supervision.

Master EC-200 Specifications

General

Brand	Master
Model	EC-200
Category	Power Tool
Language	English