66
EN
start at speed of 1.0km/h.Speed can be adjusted by pressing SPEED+,-. The machine stops when distance
shows 0.00.
CALORIE count-down training: Power on the machine, press CLEAR/SET three times, calorie figure
glitering, showing 50CAL. Press SPEED+,- to choose the calorie between 10-990CAL. Press ON/OFF to
start at speed of 1.0km/h.Speed can be adjusted by pressing SPEED+,-. The machine stops when calorie
shows 0.
3.2 Getting Started
Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the power switch located at
the front of the treadmill below the motor shield. Ensure that the safety key is installed, as the treadmill will not
power on without it. When the power is turned on, all the lights on the display will light for a short time.
3.3 Self-Checking
When using for the first time, it is necessary to make the machine carry on self-check:
Remove the safety key, press MODE and hold, then insert the safety key again, the machine enters into
self-checking state. During this state, pressing ON/OFF two times, the machine begins to self –check.
Incline motor goes to the top automatically, then goes to the bottom automatically.
After that, 888 shows at the right of the display, press CLEAR/SET 3 seconds to exit.
Note: Don’t stand on the machine when self-checking.
3.4 Quick-Start Operation
Press and release the ON/OFF to begin belt movement, at 1.0 Km/h, then adjust to the desired speed using
the ‘+’ or ‘-’. You may also use the quick speed keys (3, 6 and 9) to adjust the speed.
To slow the treadmill down, press and hold the ‘speed -’ key to desired speed. You may also press the rapid
speed adjust keys: 3, 6, 9.
In a state of running, single press ON/OFF, the walking belt will gradually slow down.
In the state of running, single press CLEAR/SET will reset time, distance, calorie.
3.5 Incline Feature
Incline may be adjusted anytime after belt movement.
Incline can’t be back to 0 after removing safety key.
Incline can be back to 0 after starting machine again.
To Next Page
Loading...
Need help?
General
