6
ZEUS TECH CO.LTD, SHEN ZHEN, CHINA
Attentions
Use restrictions
1. The displays screen and illustrations (such as key markings) in this manual are for illustrative
purpose only, and may differ somewhat from the actual items they represent.
2. The contents of this manual are subject to change without notice.
3. In no event shall Shenzhen Zeus Technology Co., LTD be liable to anyone for special, collateral,
incidental, or consequential damages in connection with or arising out of the purchase or use of these
materials.
4. Shall Shenzhen Zeus Technology Co., LTD not be liable for any claim of any kind whatsoever against
the use of these materials by any other party.
5. Avoid use and storage in areas subjected to temperature extremes. Very low temperatures can cause
slow display response, total failure of the display. Also avoid leaving the scanner in direct sunlight,
near anywhere else it might be exposed to very high temperatures. Heat can cause discoloration or
deformation of the scanner's case, and damage to internal circuitry.
6. Never attempt to disassemble the scanner or tamper with the connection settings without permission.
7. Never press the keys of the scanner with a ballpoint pen or other pointed object.
8. Use a soft, dry cloth to clean the exterior of the scanner. If the scanner becomes very dirty, wipe it off
with a cloth moistened in a weak solution of water and a mild neutral household detergent. Wring out
all excess moisture before wiping the scanner. Never use thinner, benzene or other volatile agents to
clean the scanner. Doing so can remove printed markings and can damage the case.
Temperature
：
0
～
60℃
；
Humidity: relative humidity below 80%.
10. Don't connect to diagnostic test sync when examine the ignition system sparking voltage Test, or
high-pressure disturbance may result in equipment damage
Checking when use
1． Check whether the ignition is on.
2． Check the whether the scanner's power light is on (red light), when testing the system whether the
3． check the diagnostic cable and the interface whether is bad contact or short-circuit.
4
．
Check whether the software version is applicable to the vehicle types
To Next Page
Loading...
General