Master NRB-25 User Manual

7
OPERATING INSTRUCTIONS
! CAUTION: Indicates hazard that could result in minor personal
injury and/or product damage.
CARE: Indicates hazard that will result in product
damage. PRE-USE CHECKS
1.Check oil level.
2.Check condition of bender blocks and tightness of bender block
bolts. 3.Check that the power source is appropriate to the bender
CARE: if voltage is too high,the motor will burn out.If the voltage
is too Low,insufficient power will be generated.Never use DC
power.
4.Check that power supply is properly earthed.
! CAUTION:Failure to earth power supply may result in electric shock to
operator.
5.Check that cord is undamaged and that plug is not loose.
If an extension cable is to be used,make sure that it is undamaged and
that it is the proper thickness for the length.See table below.
Cable length
110/115V
230V
Cable size (AWG)
Nominal diameter
Up to 10m (33 ft )
16
1.0mm²
Up to 15m (50 ft )
14
1.25mm²
Up to 30m (100 ft ) 10 1.5mm²

Master NRB-25 Specifications

General

Brand	Master
Model	NRB-25
Category	Construction Equipment
Language	English