REPLACE THE PROPELLER
Hold the propeller blade and loosen the propeller knob. It can be done counter clock-wise manually without tools. Pull the
propeller straight off. If prop is stuck, grasp one blade with one hand and tap on the backside of the opposite blade lightly with a
rubber mallet, until the propeller comes off. If the propeller pin is bent, replace it. Align the new propeller with the propeller pin.
Re-install the propeller knob and tighten firmly by hand clock-wise. (F)
(F)
Warning:
Make sure that the motor has been disconnected from batteries before replacing the propeller.
Do not strike bent prop pin with hammer to remove pin. Damage to motor armature may occur that would not
be covered by warranty."
（G） （H）
Fin Installment
Take out the plastic fin out of the accessory box. Loosen off the screws. Find the screw holes on front endbell. Keep the fin and
screw holes aligned. Insert the fin and re-tighten the screws.
Make sure the screws are properly tightened to prevent the fin from loosening. （G）
Handle Installment （ONLY FOR P SERIES）
Find on the aluminum pipe the sticker securing the marble and carefully tear it off. keep the handle aligned with the aluminum pipe.
Adjust the direction in accord with the plastic part on top of the aluminum pipe.
Adjust the angle to push in the aluminum pipe to the handle. Lightly press down the marble to get through the handle. Once hear
the “click” and push the handle to the end, means the handle fully in place.
Note: This is a one-way installment. Once installed, DO NOT attempt to pull out the handle again, or the
self-locking unit can be damaged. (H)
To Next Page
Loading...
