SPEED CONTROL
The speed control, featuring five forward and three reverse speeds, is integrated into the handle. Turn the handle clockwise to
move forward and anti-clockwise to go backwards. When you don’t want to move, set the handle into neutral. No power will be
used in this setting. (D)
Warning:
Remember always disconnect from batteries once the motor leaves water as a rotating propeller can cause
personal injury.
Remember to wash the motor by using fresh water after used it in salt water as it can greatly reduce the
possibility of corrosion.
ADJUSTING THE TILT/EXTEND TILLER （ONLY FOR A SERIES）
Your trolling motor features 7 usable handle tilt positions: 45°, 30°, and 15° up and down from the 0° (horizontal) position. To use
the down positions, you must first press the release button located on the left underside of the pivot handle. Your trolling motor
handle also features a unique stow position, that is useful for limiting the amount of space required for storage or travel.
Important: BEFORE attempting to put the handle in the stowed position, the speed selector must be in the
OFF/STOW position . Failure to do so will damage the internal mechanism.
First press the release button located on the left underside of the pivot handle, then push the handle down until you feel the handle
“lock in” to the stowed position. This will be almost parallel to the motor shaft.
To extend the handle, pull the handle towards you to the desired position. The handle will extend a full 6 inches. To retract, push
the handle in until it meets the face of the motor control head. (E)
(E)
To Next Page
Loading...
